Velocity Labs shows you how to set up and and install a Tial MV-S wastegate. We cover installing the springs, setting the boost pressure (psi), installing the vband clamps and hooking up the boost lines. You can find the MV-R and MV-S waste gates, and buy directly on our site TiAL MV-S 38MM Wastegate Kit with
Tagged under: , ,
The “Build Tune Race” Turbo LS Nova gets it’s first start up with holley efi. In this episode he goes over basic settings in the holley efi and getting the car running for the first time. Jared’s Turbo Nova is running the Holley Dominator EFI system a 402ci ls based engine billet 85mm borg warner
Tagged under: , ,
Valve springs are one of the most critical, and most often overlooked, components in your racing engine. The incorrect selection of the racing valve springs is one of the leading causes of engine failure. In addition, many racers suffer failure due to the incorrect installation and improper handling of the valve springs. Watch Brian Tooley​

CTSV and ZL1 Supercharger Belt Guide

A guide to the supercharger belt required for your 09-14 Cadillac CTS-V and Camaro ZL1 Below is a list of simple and complex combos, as well the belts and part numbers required All part numbers below will be the Gates Green HD Belt, along with it’s length, pulley ratio, amount of blower OverDrive (O.D), Pulley
We get this question a lot, there is much confusion and not a lot of solid info out there. The LS series of engines use two different style camshaft retainer plates. The earlier engines and most of the trucks use the typical plate with 4 non countersunk bolts. OLD STYLE PLATE – Flat plate with
Tagged under: ,